Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have been trying to work through an ongoing lock-up issue on a pair fo WAP321's. Have read many of the prior threads and have tried to get some feedback from data from either the switch or the AP's to help figure out where the problem may be, but am...
I've been trying to work around a problem that has been driving me nuts for a long time. As far as I can tell IP INSPECT on 871's and 1811's (models I've tested) using a range of IOS versions from 12.3.8 to 12.4.11t can not handle sending traffic ov...
Has anyone run into a PIX reporting back a large number of these errors which show up as recv errors in a "sho crypto ipsec sa"?Debug message:IPSEC(cipher_ipsec_request): decap failed for 24.x.x.x -> 64.x.x.x IPSEC(sw_esp_decap): fail antireplay chec...
I'm trying to migrate an ACS for Win (v4.0.1.27) to ACS SE (v4.0.1.42) but it fails as the versions are different.Does anyone know if an upgrade for ACS for Win to 4.0.1.42 exists? Or if a distribution image of ACS SE 4.0.1.27?
Has any one ever recieved a "Cisco SDM is not supported on this OS. Setup will close now." message when trying to install SDM2.2 or 2.2a on a Win200Sp4 box running VMS2.3? The server install is brand-new and is patched-up to today and this was worki...
OK, I think I've fixed it. I cranked the MTU down to 1300 from 1340 and enabled the ip inspect both in and out on the outside interface of the router. Seems to work much better now...
I'm experiencing the same problem with a tunnel between a Pix-515 and an 1811 router. The 1811 is a new addition (where Pix-506's are used on other tunnels) and has been a nightmare.I upgraded from 7.0.4 to 7.0.6 and that fixed half the issue. I no...
I've encountered the same problem on an ASA-5510 running 7.1.1 & 5.1.1. ASDM access was working for awhile, then after a reboot to fix a strange VPN problem I could no longer connect using ASDM. The ASDM launcher would get to 90% and hang "loading ...
Update:I've built another VMS server, did not install all the updates after SP4 and have run into the same problem.The VMS that I am using is 2.3 NFR. In the previous install that did work I used VMS 2.2 Basic and then ran all the updates to get it ...
The problem isn't on the router, that is running fine.The problem is installing the SDM application on the server. It is a Xeon 3.2Ghz w/2GB of RAM running Windows 2000 Server SP4 with all the updates up to 5 January 2006. IE 6 sp1 & Java 1.4.2_08 ...
