we have an ME deployment with two1852i
now we bought 4x C9115AXI-EWC-E
can you tell me if its better to create the Ewc new deployment and then join 1852i as “members” of the new “cluster”? ( assuming upgrade to 8.10 on the ME)
Are they com...
On ASA 5516 with 18.104.22.168 is there any limit on creating network object or network groups and assigning them to security policies?
We need to add, to an existing block rule, more than 950 IP addresses ( as hosts) and then assign them to a poli...
Hi AllOn a Asa ASA5516-FPWR-K9 , base license only is it possible to block via a rule, some domain or site URL?I can block some IP's or networks, but not able to see how to block a domain or site Can you help?Firewall is running on versions:Cisco Fir...
also be aware of the version that old 1832i have.
i found easier to update first the ME to a 8.10 version and then to the conversion to capwap. After that , it should be more smooth the joinning to the EwC
see also this:
thanks it worked good , with external DHCp
LAb completed successfully!
Cisco 9115 as EWC, mixed with 1852i , all on version 17.9.
Final stage is to implement this on a running ME with 1832i and 1852i AP's.
I will upgrade the ME to 8.10 , th...
Yes. I was reading about the vlans. In the ME it was possible to get vlans and DHCP inside the controller.
SO in the EWC virtual controller we should only configure the vlans info on the flex profile , assign that to the AP's and put inside ...
Hi All almost at the end of the configuration of c9115axi. Working with default vlan 1 now.
Its not easy or straightforward but we get there.
I have now vlan X for AP mgmt and vlan Y for SSID
I have configured the SW port as trunk with both vlans X,...
After a few time I am back
I have 2 AP EWC capable on, but when I disconnect the current active controller , there is no standby.
What could be the cause?
Monitoring says that stanby is disabled
Could you help?