Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to terminate two dls connections to the same provider in a single router. I have two HWIC interfaces in the Router. The router is a Cisco 1841 series.When the dsl line is connected to Slot 0, router is connects without issue. When I co...
Hi,I am trying to setup failover on a pair of Pix 515E.One interface is setup to be a vlan interface. There logical interfaces are defined from this interface. I have setup failover ip addresses for each of the logical interfaces, however I getting t...
Hi,I am currently working through the release 7.0(1) documentation prior to upgrading a HA pair of 525 Firewalls. The version of software that they are currently running is 6.3(4)From reading the Application Layer Protocol Inspection guide, there see...
Hi,I have a requirement to allow two separate sites establish a VPN to our Cisco Pix. The Pix will terminate the VPN for both sites, they both need to access the same resources on the private lan, however we need to bring one of the remote sites thro...
Hi,Sorry for taking so long to reply. This is a snippet of the config:interface ethernet4 100fullinterface ethernet4 vlan5 physicalinterface ethernet4 vlan2 logicalinterface ethernet4 vlan3 logicalinterface ethernet4 vlan4 logicalnameif ethernet4 vla...
