Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've discovered recently that whenever I cold boot or reload one of my Cat2960S switches with my new Cisco 1GB USB stick inserted, it does, well, nothing.... No console output. It just sits there with the status lights extinguished.Take out the sti...
If I run the command "sh controller utilization | include Stack" on my 7 node Cat 3750 stack I get a % utilization for the stack ring. I've poked around some, but cannot find any OID info for this statistic. Has anyone else found such a thing? Is ...
The USB is in when I turn on the power for a cold boot. Read "inserted at boot time" as "if I insert the stick and then cold boot." Also to include if the stick is left in during a reload.
I wasn't clear in the original post, but the USB stick is an official Cisco stick. MEMUSB-1024FT= or something like that. It works perfectly well so long as I'm already in IOS or ROMMON. The system is booting from flash and always has been.If the U...
