csyeo
Level 1
Level 1
Member since ‎01-22-2001
‎08-08-2021

User Statistics

  • 28 Posts
  • 0 Solutions
  • 0 Helpful votes Given
  • 0 Helpful votes Received

User Activity

Hi,I have setup as below;CME--> H323 --> IPIPGW --> SIP --> CCMWhen i initial a call from CME phone to CCM phone, the phone at CME just keep on ring out even when the phone at CCM side pick up, my dial-peer config as below;CMEdial-peer voice 100 voip...
The output as below;tok-fr-rtr>sh call hist voice brief<ID>: <start>hs.<index> +<connect> +<disc> pid:<peer_id> <direction> <addr> dur hh:mm:ss tx:<packets>/<bytes> rx:<packets>/<bytes> <disc-cause>(<text>) IP <ip>:<udp> rtt:<time>ms pl:<play>/<gap>...
Hi,Anyone know what is the interface type for E1 PRI use in Taipei (Taiwan) and Seoul (Korea), .e is it using 120 ohms(RJ48) or 75ohms(BNC).cheers!csyeo
Hi All,Anyone know where can i download the visio stencil ( cm_cisco.vss) for the campus manager.cheers!csyeo
Have anyone try out mixing of different IOS QoS feature on a same router such using Weighted Fair Queuing together Generic Traffic Shaping.Is there any constrain on this type of implementation.thanks.csyeo
Community Statistics
Member Since ‎01-22-2001 09:59 PM
Date Last Visited ‎08-08-2021 10:45 AM
Posts 28