Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, can anyone assist with an issue I have with a Cisco 887VA Router, in that there is no outbound Internet access. I cannot reach the Internet from the router or any workstation connected to vlan1. I know it is a ACL issue but not sure what I am mis...
Hi,I have tried replacing a faulty Cisco 2621 camera with a brand new one. I give the new camea the exact same IP settings as i do not want to have to delete and add it again in VSOMThe problem i have is that when i do this, VSOM still has an endpoin...
Hi all,I have tried to upgrade a CPAM Gateway module from 1.3.2 to 1.4.1 but have a problem. This gateway will not take an upgrade file and has now stopped operating correctly. It got to the stage where it said downloading file. But never recovered. ...
Hi,Has anyone ever had an issue where they are not receiving door events from doors. I have a project with 450 doors but have not received any door events from 40 doors for the last 6 weeks. The doors are associated with two gateways. I can send comm...
Hi all,I am having an issue on a clients laptop where they cannot fast forward through an archive. This was working last week prior to some windows updates being installed by the client. The problem is that when you go to an archive and drag the bar ...
Hi John, i meant to say by not having ACL 100 IN will this affect external. Also, since changing ACL199 I cannot reach my internal servers from external anymore from an IP address I have configured on Access-list 100 permit ip external ip any. ??whe...
Hi John, By removing acl100 from diaper 0 in I can ping outside from router but not from a workstation on 192 range. Also , as I am using nat to allow external addresses to reach internal ports by not having the ACL 199 in will this affect connectivi...
Config below: Building configuration...Current configuration : 5050 bytes!! Last configuration change at 13:38:09 UTC Wed Oct 14 2015 by root!version 15.4service timestamps debug datetime msecservice timestamps log datetime msecno service password-en...
Hi John, Thanks for the reply. Please see config below and let me know where I have went wrong. I am fairly new to this so please show me corrections on config. Building configuration...Current configuration : 5050 bytes!! Last configuration change a...
Hi Caleb, what server are you using?what version of clam are you at? I was advised by Cisco tac to upgrade to 1.5.1 at the time, and I believe there is a 1.5.3 out.It was possibly a memory issue on the physical 1RU server. Kind regards,Finbarr
