Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 2 isolated networks, the 1st is 10.x.x.x and the 2nd is 192.168.x.x. I have a point to point connection between each network. I have multi-interface routers at each end. On the 192.168 side I have one interface assigned a 192.168.68.x addre...
We had an isolated network (10.1.x.x-10.5.x.x) in a remote location for a period of time. Over the last year we installed a T-1 that provides us (our main office (192.168.x.x)) connectivity to that isolated site. The setup was configured as follows...
I need to allow multiple clients on my internal network that are using internal addresses to establish a PPTP VPN connection via Windows 2000 native VPN client through my PIX 515 (version 6.1) and 2600 Router (version 12). Currenlty I do not have an...
I am looking for a VPN solution to support 70+ remote sites. Each one of these sites already has a network in place. I would like to add a VPN enabled device at each site that will allow approximately 20 concurrent connections. I would like the de...
I've read that the conduit command was neccesasry to allow traffic to your net devices to bypass the rules on your PIX, that is for the older IOS versions. It has since been replaced by the access-list command. I am currently using both. I would like...
At this point I am only concerned about reaching 2 devices from the 192.168 network. Here are the routes for each device. One is on the 10.5 network and the other is on the 10.1 network.10.5.1.60set interface sc0 50 10.5.1.60/255.255.255.0 10.5.1.2...
On the router attached to my 192.168 network:interface Ethernet0 ip address 192.168.68.x 255.255.255.0!interface Serial1 ip address 10.7.1.x 255.255.255.0!router eigrp 1001 network 10.0.0.0 network 192.168.68.0ip classlessip route 0.0.0.0 0.0.0.0 192...
Actually the problem turned out to be with the config on my external router. After entering the following it worked:access-list 100 permit esp any host 209.51.172.216access-list 100 permit ahp any host 209.51.172.216access-list 100 permit gre any ho...
i am having the same issue. I successfully establish a connection with my 3.5 client to a PIX 515 ver 6.2. I pull down an address but I cannot ping or access anything on my network.How do u bind it to the proper interface.
disregard the above...some of the message was left off.I used the Cisco PIX device Manager v2.0 to configure a client to PIX VPN. The configuration completed without errors. When I attemp to connect I pull down an address from the pool that was cre...
