Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm trying to do transparent bridging with the following setup but im unable to pass traffic from R1 to the PE router. My goal is to use R2 as a L2 bridge to get connectivity between R1 and PE1. R1 doesn't have the necessary module hence this setu...
I’m trying to add a QoS for each service instance to prioritize traffic on ME3800. Below are the config im trying to use, however I’m getting error when applying it.policy-map Child-Policy class CM-Voice priority police cir percent 35 bc 25 ...
Yeah the IPCP negotiation between R2 and PE1 is problem. Works fine if R2 multilink has an IP but defeats the purpose of it being a L2 device only. Thanks Rick.
Hi Margalla,Thanks for the inputs apparently I don't manage the PE router which I stated before and i don't think my SP will configure bridging on their PEs.
Thanks for the inputs Rick! Sorry if I was not clear enough on my post. I'm doing this on the lab in preparation so I can expect what the behavior of the PE router will be during the cutover. The /30 network which im not seeing being installed is on ...
