Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone!I am configuring a Site-2-Site VPN but the other end (that I do not manage) is configured with DH group 14 (2048bits) both IKEv1 and IPSec sections.I tried to configure this connection in my ASA but I can choose groups 1, 2 and 5 only;...
Hi all,I am having some routing issues with a L3 switch. Firstly, I am following this document in order to complete my configuration, but it is working quite odd... http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a0...
Hi all,I have configured 4 interfaces in my router:Fa0/0 --> LAN (inside)Fa0/1 --> Internet (outside)Fa0/2 --> Supplier1 (outside)Fa0/3 --> Supplier2 (outside)I have several NAT rules from LAN to "outside" interfaces and from outside to LAN working f...
Hello all,First of all, excuse any language mistake, I am not an English native speaker but I will try to do my best I´ve been trying to configure a connection which requires NAT translation but my devices are too old and seems that the configuration...
Hi, Sorry, I have found the problem, the problem was not on the switch nor on the router, it was a routing problem on the rest of the network devices on the internal network...Thanks for your help and sorry again... Jose
Hi Rolf,First of all, thanks for your answer and sorry for the mistake, I copied from my text config file, but it is ok in the running configuration:SWSB-HQM-LAN01#sh ip interface brief vlan128Interface IP-Address OK? Method Status ...
Hi again,I just configured the syslog to be saved in a server on 192.168.10.0/24 network and it is working perfectly :$ seems like it is not working with TCP traffic only (https server doesn work either)Regards,Jose
Hello everyone,I think I did it!!!! Source and destination translation from outside to outside (not exactly but at the end it's that)I will copy below the configuration on the "middle" router; it translates an initial packet 172.22.26.100 --> 192.168...
Hi,I'm doing many many tests but I think it is not possible to solve this with Cisco routers (probably with other devices would be possible...). - With ip nat inside/outside, the translation only occurs when the traffic flows from inside to outside a...
