Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm currently running X86_64_LINUX_IOSD-UNIVERSALK9-M and encountered a bug that reboots the router. TAC advised I upgrade the IOS. I'm looking at X86_64_LINUX_IOSD-UNIVERSALK9-M. Are there any considerations I should take into account?
I use images loaded in a USB flash drive that I upload into a switch just because it's faster than using tftp\ftp in some of the offices I go to. I usually just pull the flash drive out when I'm done. Once in awhile this corrupts the USB stick. Is th...
I'm going to upgrade the IOS on a 6509. I have the new image loaded and just want a confirmation that the boot statement I have on it is correct.Here's what I have in the config:boot-start-markerboot system flash bootdisk:boot system flash bootdisk:/...
I'm reading the IOS 15.0 documentation for the VSS configuration. There are 2 ways to do the Dual Active Detection PAgP and Fast Hello. The documentation doesn't go into the pro's and con's of either one. Does anyone have experience with this and pre...
In IOS verson 12.X there was a Bidirectional Forwarding Detection configuration however in IOS 15.0 this isn't available at least not with the same syntax. Is this feature not available in 15.0?In 12.X this was the syntax of the command:switch virtua...
BB
Here is a
sho ver
Cisco IOS XE Software, Version 16.09.05Cisco IOS Software [Fuji], ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 16.9.5, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupportCopyright (c) 198...
You can connect a laptop to it and see if the problem continues. If not then you have a problem either with the wiring or the end station. If it persists then check the port. While it's rare it's not impossible to have a hardware issue with the port....
