Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm trying to decide if I should use my MX250 as my default gateway for multiple subnets instead of a Layer 3 switch that would subtend off of the MX. In the past I have used a Layer 3 switch as the default gateway because of it's ability to route p...
I have been reading for awhile now on all the Cisco forums on the 3560 and shaping egress traffic but I wanted to verify my thoughts on this. I have 3560 that connects to the ISP that is policing at 10Megs, I want to shape my egress traffic going to...
All, here is my current setup: Windows XP machines authenticating wireless using 802.1X to a Cisco ACS 5.3 that redirects the request to Microsoft Active Directory. All the statements that I make below are what I have gathered from reading on forum...
Good morning, I have a similar question and was curious what your final configuration looked like. Did you end up taking a link directly off of the Inside interface of your firewall to your WAN MS switch? Did you create a separate mgmt vlan/network o...
I did read a little on the "bandwidth limit" command but I found another forum, where people reported some issues. Is using the bandwidth limit command better than the shape command? What do you think of my shape command is it correct? Here is wher...
Simon, I was able to get the XP computer working by setting up a profile to authenticte "Machine Auth" only, when I tried to authenticate both machine and user it fails. At this point I am sticking with machine only.Thanks,CM
