Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a cisco NAC Manager v4.6.1 when i restart it, the boot freeze at this msg <ext3 fs mounted filesystem with ordered data mode>and it take a very long time.Note:The server is pingable but no GUI access during the msg.The screenshot display...
i have a Cisco CAM version 4.8.3 and i want to downgrade it to 4.6.1, i have the tar file of the version 4.6.1, any one can provide me with the right steps of the downgrae operation.
Hi,i have a small problem: i want to create a ASA remote acces VPN to my site, the schema is as the following:ISP---} Internet Router 2800 ----} Edge SW(2960G) ------} ASA(5540) -----} Core SW (6513E)ConfigurationInternet Router Outside Interface : R...
the problem was i already work by version 4.6.1 but the system crashed completly and the only installation CD i have is version 4.8.3 so i installed it but the snapshot (Backup) cannot be restored bec of it was version 4.6.1, so i need to downgrade f...
Dear Jennifer,Now i create this ACL from CLI on the ASA : "access-list OUTBOUND-TRAFFIC extended permit ip any PIV_VPN 255.255.255.0"(vpn client subnet is 172.20.200.0/24)and the inside users subnet "10.21.10.x/24" can access the vpn client laptops o...
no i dont have a split tunnel on the ASA,the default gateway inside is 192.168.21.1, i have a IPS IBM Provintia inside between the ASA and the core switch....but even the IPS block the traffic why i cant ping the inside asa interface IP
,Dear Jennifer I configured the 2800 router with the nat rule as u say and i worked now, but i cant access the inside zone (the servers or the hostes)u can find the attached image of the NAT rules i already configuredThe VPN pool is 50.0.0.0/24
