Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, My company is having a routing or load-sharing problem so I hope you can help me. The following diagram is the current situation: I don't know when the direct layer 2 connection between SW1 and SW2 went down, the link is a 20km fiber connection b...
Hi Guys, I need some tips for the Cisco Anyconnect and DNS problem in my office. Environments:Cisco ASA 5515-X 9.12(2)9Cisco AnyConnect 4.2.03013Windows 10 1903 My organization has over 10 Forward Lookup Zones on the global DNS servers, one of the do...
Hi Guys, I'm suffering a problem that about PBR and VLAN Interface on the Catalyst C9300-24UX, Cisco IOS XE Software, Version 16.06.03. My question is, I created a route-map and access-list as my PBR configuration, and then applied on VLAN 1, but the...
Hi Guys,
Recently my company purchased 2 Cisco Catalyst 9000 switches with DNA Advantage software license,
I noticed the DNA Advantage software included Encrypted Traffic Analytic(ETA) feature, but we don't have any NetFlow collector like StealthWa...
Hi Guys,
My customer has 2 Cisco TelePresence device SX10 and SX20, both are registered to their Cisco VCS,
2 devices works well, only a problem that the timezone always back to default setting,
even through I changed it to correct, it will change b...
Thank you for helping! Unfortunately, we cannot remove the connection and connect between SW3 and SW4, as the switches are layer 2 switches (Cisco IE3000 series), and due to the distance issue, we cannot make the engineering very easy. The VLAN Inte...
Hi Richard, Thank you for helping! You are right. The disconnection between SW1 and SW2 is the fundamental problem (Sorry I haven't explained it well). We wouldn't like to make any changes to the physical connections because the engineering will tak...
Sorry for the late response. I read the article and followed the below section but I couldn't find the cause. As far as I know, everything works on the LAN, so I was wondering if I missed some configuration on the Firewall. I think I will find a goo...
Hi Georg, I changed the wildcard mask in the access list, but the issue still same This's my current only ACL in the route-map on the Interface VLAN 1:'access-list 110 permit ip 10.99.99.0 0.0.0.15 192.168.56.0 0.0.0.255' However after I applied th...
