Problem with the move is it needs the Virt-IO drivers in the VM before it can be copied, or root access to install. I am not sure if it is possible to make that happen on a security type appliance. If you can get the drivers installed ahead of moving it though...it should work. I have spun up FMC 220.127.116.11 in AHV and it seems to be working fine. I am having issues with spinning up the virtual FTD in AHV, if anyone has success with that, let me know.
... View more
I have an issue where UDP packets are constantly being dropped through a 2811 router. When I do a show vlan 600 I get the following: Vlan600 is up, line protocol is up Hardware is EtherSVI, address is 0025.84fb.7590 (bia 0025.84fb.7590) Description: Cisco Management Segment Internet address is MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability 255/255, txload 1/255, rxload 2/255 Encapsulation ARPA, loopback not set ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:00, output never, output hang never Last clearing of "show interface" counters 1w6d Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: fifo Output queue: 0/40 (size/max) 30 second input rate 1037000 bits/sec, 176 packets/sec 30 second output rate 57000 bits/sec, 78 packets/sec 198077267 packets input, 2636187411 bytes, 0 no buffer Received 12450725 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored 88773918 packets output, 3948583617 bytes, 0 underruns 0 output errors, 0 interface resets 95053 unknown protocol drops 0 output buffer failures, 0 output buffers swapped out The counter continually increases. I tried to setup a span session with the VLAN on the Router, but got the following: (config)#monitor session 1 source vlan 600 SPAN Source Vlan is not supported in this platform IOS: Version 12.4(15)T9 How can I find out why these packets are being dropped?
... View more