Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all. We need to restore factory defaults on a CSM 4.0 SP1 server, and need to do it without re-installing the server. Can't find an option to do this, so that CSM can start from scratch with no devices or policies, and with all default setti...
Hello all. Does Cisco provide frequent rules updates for CSA? If an application like Call Manager changes versions and adds/changes functionality, CSA rules should change as well. Is there a download site for these updates, or is it part of the servi...
Hello All. I'm setting up a lab with the following applications, for training purposes:CEMF 3.2 and EMS for GSR 12000 v. 3.1.1 and 7600 routers v. 3.0)CNS C-Note (Notification Engine) v. 3.0CNS Performance Engine v. 2.0CNS Netflow Collection Engine v...
We have tried to use PC Anywhere as a remote control tool for Call Manager 3.3(3), with no success. It works, but we loose conectivity to CM via http. Does anybody know if this is due to PC Anywhere? If so, can you recommend another remote control to...
Can that be done (Sending router alarms to IEV or CPSM via PostOffice)? I was trying to configure a 2621 with IP PLUS FW/IDS 12.2(8)T for postoffice interaction, but the command "ip audit po local" does not include parameters to configure Host Name ...
Thanks for your reply. This is for a training class, so we don't expect more than a couple of devices sending traps to CNote and then CNOte forwarding them to Infocenter in a controlled lab environment. The same devices will be monitored by VPN Solut...
Thanks a lot. My research shows that some of the applications are disk intensive, and so having 2 disks will make performance better. This is a training class, so fast is important to fulfill all objectives in time. Any comment?Thanks again !
Thanks for your response, Marco. I could not find, however, a reference to host NAME and org NAME in the link you provided. The command does include parameters to set the host ID and org ID, but not the host NAME and org NAME.Have you done this? Have...
