Hi Everyone The Problem:I was on the Cisco 3750 switch stack(SW1/SW2) at our Datacenter via putty SSH using the IP of 10.224.14.103. This IP is configured on an SVI. I needed to power off the master(SW2) and move its power cord into a different powe...
HiDoing a s/w inventory on systems in our network and the result is showing multiple versions of VPN Cisco Client installed. Is this possible or are the older versions remnants left behind after an upgrade... ThanksPHCCXXXXXXXXCisco VPN Client4.8.1....
Hi All,I uploaded a new config file via TFTP to a 3560 switch. What are the order of commands to get it to boot from this new config file instead of the file listed in 'sh boot':Directory of flash:/ 2 -rwx 10468443 Feb 28 1993 19:51:11 -05:0...
HiCan you set up one next hop PBR for multiple subnets and apply the PBR to multiple interfaces? I need to send Voip vlan traffic in one direction and data vlan traffic in another. I was going to create an extended ACL that included all the data su...
HiCurrently I have a distribution switch(Cisco 3750) that sends all traffic (voip and data) to an edge router. The edge router has 2x PSTN circuits for voip and fios circuit for data. I need to send the data traffic from the 3750 to a firewall whic...
I agree Jon, that is not really a good answer. The tech was not very helpful and we went around in circles on the issue. Anyways, my main point of contention was, what is the point of having a stack if it is this vulnerable to failure if the maste...
Thanks to everyone for their help on this. I decided to modify the existing config and not take any chances. I thought that the using the other config file would be the quicker and more painless way to get this replacement switch up and running......
Thanks for the info guys! One more questionDoes it matter that the config I am going to use is from a Fast Ethernet switch and this one is a Gigbit??Both are 3560 series PoE switches with same # of interfaces