Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey folks,
I am trying to clear the xlate table from a Catalyst 3750. The command below is not available to me via the CLI. Has the command changed?
clear xlate
Tried in both modes.
Thanks - Robert
Hey folks,
I have been experiencing some issue with bandwidth through our C2900 ISR. I have a 500 Mbps circuit that is symmetrical. I am getting 392.06DL/286.96UL. I have been working with our service provider and we have confirmed that their equipme...
After connecting succesfully with Cisco AnyConnect version 3.0.05152 I am unable to access internal resources. Below is the configuration of the ASA.Any input on the below would be appreciated=~=~=~=~=~=~=~=~=~=~=~= PuTTY log 2014.02.04 16:15:58 =~=~...
I have been looking for the command to view all concurrent active connections or sessions on our Cisco 2911. I want to see what the total connections or sessions are at peak times throughout the day. Does anyone have the command for this? Thanks - Ro...
Joseph,
I have a Catalyst 3750 that can handle L3 you think the Gig interfaces on this device can handle the throughput or do you think I would likely run into the same overrun issues as I am seeing on the ISR?
Robert
Thank for the response Reza. the overruns accumulate under normal load as well. When I clear counters I am able to see as substantial increase when pushing the circuit. Under normal network load the counters increment much slower.
The model is a 2911...