Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
this is my first post in this forum ^^, so hopefully you guys can help me out with my problem,
so, i have running RV130W as my router for almost a year, and everything perfectly running well. but now i want to use VPN ipsec due demand from ...
hi all
i have a little problem with my asa, which is, a host that connected to outside interface cannot connect to host that connected to inside interfaces. my ASA currently running Transparant mode, and following is the configuration of my ASA. for...
i have plan to deploy cisco WAP321 on my customer, and after rading the document about WAP321, it said the WAP321 support for VLAN ID feature, but i cant find whether it support for trunk port because i would like to connect the WAP 321 LAN port to t...
hi all
at last i finally figure it out how to solve the problem, which is the problem is comes from my RV130 which is not configured correctly. the configuration that i talk about is the NAT traversal settings, after i set it up now i can connect t...
hi miranda
thanks for the link of vpnclient of cisco and also the link of the forum, but currently i have windows 10 installed on my PC, and it seems your software doesnt work for win 10 (i will try on my wind 7 virtual).
and for 10.10.10.10, it ...
thanks for the reply,so i need only to set the trunk port on the switch right ?? btw this is my first time working with cisco SMB devices, is there any big differences between the SMB and the enterprise devices, especially for the command
