Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys
Does anyone know the definition/output of NX-OS command “show hardware internal carmel crc”?
The output is eight column table, like below. I can’t find explanation of the column names like MM tx CRC etc.I know about Tx Rx and CRC, but not the...
Hi groupI have a question regarding LAG in HA setup; do you configure two port-channel, one for each controller or, only one port-channel for both?I have a stack of 3 x 3750x, and 2 x 5508 with each two Gigabit uplink in use.Active controler (5508-1)...
Hi guysI have an odd issue after upgrading from WISM1 v7.0.230 to WISM2 v7.4.100I have made an AP Group an added all my WLAN (SSID). When I move AP from Default-group in to this group the new clients don’t get an IP address on any WLAN (SSID) When I ...
Hi GuysMy company is beginning to have a lot of sites were we are stacking 3 to 4 C2960S-48 switche.This is making "show running-config" very very long because of the 4 x 48 interfaces.I can’t find a CLI command that show me the running-config of a r...
Hi I use WCS v6.0.132.0 to manage my 4402 and 2106 controller both running version 6.0.182.0When I try to add another 2106 over DM-VPN it fails with the following errors:”No response from device, check SNMP communities, version or network for issues”...
Thanks Stephen for your reply.The switch doesn’t see which of the two port-channel that is on the active controller right? If WLC01 is the active one in PO1 and standby is WLC02 in PO2, the MAC of the active controller (WLC01) will be sending on PO1....
What if you have two controllers in HA setup, do you configure two port-channel, one for each controller or, only one port-channel for both controllers?TIAPeter
