Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two class C IP blocks that terminate on my router. I currently have been using an ASA 5520 to provide DMZ VLANs from one of those IP blocks and ignoring the other one. I am migrating to a 5585 now and want to add the second IP block as a ser...
I have a small network with the following configuration:AT&T 100 MB circuit terminates in their on site switch (I have no visibility)AT&T switch handoff via ethernet to my 3560 switchTwo firewalls and a soho router connected to the switch on VLAN2Swi...
I have a cisco 3560 switch set up as my edge router. It is working as my external demarc switch and edge router. It is sitting between the ISP's switch and my ASA firewall. It's a very basic configuration with port 1 set up with a fixed ip and swi...
I know that i'm late to this party, but I'm a sys admin that has recently upgraded his ASA to 8.4 code. Ever since i've been working with Cisco to get mac clients working from inside my network to external ASAs. There is an issue with the mac clien...
Turns out that I cannot do this. I have to provide VPN via ipsec and anyconnect on one of the interfaces on the production side. I have 18 vlans on the second class C and I can ping my interfaces, but once there they don't know where to go. Obviously...
I'll pull the show interface stats once I get over this cold. I was going to swap out the 3560 (almost brand new), but I don't have any other layer 3 devices. I have an old router I can swap in, but I cant do it until mid Feb when we have our next m...
Rick, thanks for your time and patience. It has 12.41.xxx.1/24 as the primary address and 12.107.xxx.1 as the secondary address on VLAN2. I've done all the testing from 12.107.xxx.1 and hadn't tried 12.41. It seems to work for everything but the a...
