Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiIs it possible to set up a non Meraki VPN without it connecting to Meraki Devices?Scenario is MX-1 will be deployed soon, I only want it to have a S2S VPN with the non Meraki deviceMX-2 and MX-3 use AutoVPN nowthanks
hiIn a topology like below, when deploying MX's in a warm spare setup, if each ISP is handing off a /29, is there any reason not to go with using a VIP on WAN1 & WAN2?And if going with a VIP, I'm not how many VPNs get configured on the other end....T...
Hi AllI cant see any mention of this in the in the documentation pages....Is it possible to use a MX just to act like a normal router connecting to a MPLS PE? So in this scenario there would be no Auto VPN requirement, it would need to advertise its ...
Hi
I'm a little rusty on IOS-XE software updates and looking for some advice
Please see below outputs, I dont recall seeing the system image being the packages file on any ISR's I've logged into before, but it has been a while. Normally I see a speci...
HiIn the following topology, what would be the best way to ensure the spokes prefer one HUB router for all routes over this iBGP route-reflector setup?HUB router config*************************************************neighbor ELAN-IBGP-PEER peer-grou...
HiYes I know the VPNS are separate, but what I mean is, to configure the S2S VPN on MX1, I need to turn it with the radio button. Which then makes it an auto VPN hub or spoke, there doesn't seem to be a way to do S2S without that. Basically get it to...
thanks for the reply Guiseppe. What I should have mentioned and failed to....I am most interested in routes coming in from eBGP into the eLAN iBGP network Both HUBs connected are connected to the same MPLS network. I want to ensure the spokes see the...
HiNo, as that command completely strips the port of all configI mean only removing the config relevant to dot1x/authentication etcThe other config on the switch port such as vlan, voice vlan, qos etc was to be leftThe method of putting no in front of...
thanks Paul
Interesting you mention the inconstent vlan ID, that was what happened during the fault that has led to this config review for the partiular customer.
During the fault the core 3850 blocked the port-channel linked to a stack of 2960's...
