About chuckk139

chuckk139 · 10-11-2007

Hello,I have setup a CISCO 1841 with the following configuration and experiencing extremely slow connections to websites over our T1 link to the Internet. I just configured this router and was wondering if anyone could find anything in my configurat...

chuckk139 · 09-27-2007

I am attempting to get a 1800 router to connect to the internet using a single external ip address to provide NAT for all client computers using the following relevant portions of the current config.version 12.4interface FastEthernet0/0 description C...

chuckk139 · 10-12-2007

Just an additional clarification. When I mean I enable ACL 101 I mean if I just so much as issue the command:access-list 101 permit tcp any host X.X.X.33 eq 1494immediately the Internet becomes unusable. No deny command nothing. I have tried this ...

chuckk139 · 10-12-2007

Spoke with the service provider, the can find no problems on their end. In addition I have noticed that as soon as I enable the ACL 101 that is when the problem begins. However I can find no difference between the ACL that I am now running and one ...

chuckk139 · 10-11-2007

This was the config between the two routersConfig on Current Router CISCO 1841interface Serial0/0/0 description connected to Internet ip address X.X.X.186 255.255.255.252 ip access-group 101 in ip nat outside ip virtual-reassembly ip route-cache flow...

chuckk139 · 10-11-2007

Could only run it for a few minutes as was disrupting the access of the 3rd shift. Show int S0/0/0 is attached.

chuckk139 · 10-11-2007

I have so far they haven't gotten back to me. The reason I don't believe it is their issues is that I use the same router with a different configuration it works fine. Basically if I use the inspect commands in my config and the specific access-lis...

Member Since	‎09-27-2007 05:54 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	14

User Statistics

User Activity

Slow to No Performance CISCO 1841 over T1 Line

access-list and NAT

Re: Slow to No Performance CISCO 1841 over T1 Line

Re: Slow to No Performance CISCO 1841 over T1 Line

Re: Slow to No Performance CISCO 1841 over T1 Line

Re: Slow to No Performance CISCO 1841 over T1 Line

Re: Slow to No Performance CISCO 1841 over T1 Line