Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hi, i have DSL connection from my service provider, he sets mtu 1492 on its dsl modem, My LAN has cisco 2960 switches which is by default 1500 mtu size. The problem is when i connect dsl modem to my LAN switches it stops browsing and when i connect i...
hi,My core router 3845 connected to my remote site with E1 links and connected to my internal network with its sub-interfaces. The following is the sub-interfaces configuration.interface GigabitEthernet0/1.1 description *********LAN IPS********** enc...
hi, i have 4Mb bandwidth terminated on my Gigabitethernet interface. when i issue sh int Gigabitethernet 0/0 i found that there is " Available Bandwidth 3072 kilobits/sec" what does it means?The second part of the question is if i the bandwidth is te...
I have configured and applied Qos successfully on my router,the following is the configuration. class-map match-any HTTP_TRAFFIC match protocol http match protocol secure-httpclass-map match-any ftp-traffic match protocol ftpclass-map match-any nbar-...
hi, My question is that is it possible to telnet router from ASA. I have configured ssh for outside. i want to ssh ASA then telnet my router placed on inside interface of ASA.Thanks
hi,Thanks all of you for your reply, actually i figure out the problem, My vlans and the DSL Lan ips are with the same network. i.e my vlan management ips are with network 192.168.1.0/24 and my DSL LAN ip is also 192.168.1.1/24. All of my vlans are a...
hi Giuseppe, thanks for your immediate reply,i have seen the serial interface there is " ICMP unreachables are always sent" i can ping my machine from remote router but i cann't do traceroute. Packets drops at the core router. My machine also pings t...
hi,my device is 3845 router with IOS "Cisco IOS Software, 3800 Software (C3845-ADVIPSERVICESK9-M), Version 12.4(21), RELEASE SOFTWARE (fc1)"sh output of sh interface is as follows:GigabitEthernet0/0 is up, line protocol is up Hardware is BCM1125 In...
here is the configuration.class-map matchany SMTP_TRAFFICmatch protocol smtppolicy-map SMTPclass SMTP_TRAFFICbandwidth 1240000then apply it on the interface e.gint fastEthernet 0/0service-policy input SMTP
