Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I installed and was able to use the Cisco Network Assistant. But when I setup the enable and vty passwords I get a dialog windows stating "Please enter your username and password for realm 'level_15_access' on xxx.xxx.xxx.xxx"what username and passwo...
I am trying to configure Management Interface on a 4506 that has a supervisor v-10GE.I followed the following stepsconfigure terminalinterface vlan 99ip address 192.168.1.245 255.255.255.0no shutdowninterface fa 3/4switchport mode accessswitchport ac...
I did a "show config" and noticed#frame distribution methodset port channel all distribution mac bothset spantree portfast 5/21-22 disableset spantree bpdu-filter 5/21-22 disable#port channelset port channel 5/21-24 779how do I clear these configu...
I tried to enable etherchannel on a catalyst 4506 with catos usinghttp://www.cisco.com/en/US/tech/tk389/tk213/technologies_configuration_example09186a008014edfa.shtmlbut the NIC cards require that STP be disabled and I am unable to find any informati...
I have a catalyst 4506 switch with CATOS version 8.4(4)GLX. Does software exist that I can use to monitor the bandwidth of the switch and each port? I basically want to zero in on the machines that are producing high volumes of traffic.
Ok, so I did switch is to vlan 1 and it worked. This is my first time working with vlans, so some basic questions. It looks like the vlans are not talking thus if I configure management of vlan 99 all pings will fail until I allow traffic to flow bet...
the status is vlan 99 is down and the line is down. I am ping from and to subnet 255.255.255.0All host are connected to the same switch and in the same subnet as the switchThe only thing I have not tried is to use the default vlan 1how would I go abo...
OK here is the current setup I have on the switch side#module 5 : 48-port 10/100/1000 Ethernetset trunk 5/21 off dot1q 1-1005,1025-4094set trunk 5/22 off dot1q 1-1005,1025-4094set spantree portfast 5/21-22 disableset spantree bpdu-filter 5/21-22 d...
OKI used set spantree portfast bpdu-filter mod/port [enable | disable | default]solved the issue with STPI'm using qcheck a tool to check throughput and I'm getting a max on 600Mbps checking from a 1gig client pc with the server that has two 1gig nic...
OK so I figure out how to setup the vlan in catos usingset vlan 2 5/21-22 state activebut I get the following messageVTP advertisements transmitting temporarily stopped,and will resume after the command finishes.Cannot add/modify VLANs on a VTP serve...
