Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I have two cisco 8130 firepower NGIPS with six 10g ports (three 10 Gbps LR Fiber Network Modules). i have to implement HA in transparent in-line mode. Can i use 10g link as HA ? or i need to purchase 1G network module ..
Hi,
we have 2 cisco 8130 NGIPS with Bypass 10 Gbps LR Fiber Network Modules, can we implement device High-availability by using this modules.
or we need to purchase Non-Bypass network modules to achieve device High-availability .
i think we can...
Hi all,
I have ASA-5525 with sfr module running as active/standby, sfr is managed by ASDM. 1. Can i take both sfr modules ip address as same or different ? (managed by ASDM) (i guess same)2. If iam using firepower management center then how can i t...
Hi All,
in my cisco 2800router i have 64mb compactflash and i want to upload 53mb ios i don't have enough free space then i removed old image and upload new ios & gave boot system command, then it should load with new IOS image. but after reloadi...
Hello Experts,
1.my lightweight AP(3502i) is not joining with virtual Wireless Lan Controller
my Ap is getting IP from DHCP , but it shows not joined in wlc, can you please tell me what was the problem,
2.is it possible to install new image in lig...
Thanks Marvin,
without state sharing interface ,can we do High Availability for transparent in-line mode for the attached topology .if possible please let me know what is the minimum requirements in network side (core-switch).
Thank ...
Hello all ,
my lightweight AP(3502i) is not joining with virtual Wireless Lan Controller
my Ap is getting IP from DHCP , but it shows not joined in wlc, can you please tell me what was the problem,
APa44c.11d3.3ae9#sh versionCisco IOS Softwar...
HI,
For me also same problem
1.my lightweight AP(3502i) is not joining with virtual Wireless Lan Controller
my Ap is getting IP from DHCP , but it shows not joined in wlc, can you please tell me what was the problem,
2.is it possible to instal...
Thank you Marvin,
1) For updating ASA with FirePOWER Services 5.4.0 to 6.0.0 , what about ASA with FirePOWER Services Boot Image , is it update automatic or we need to do any thing.
2) Is it possible to install ASA with FirePOWER Services ...
