Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have set up the ISEs to allow wired guest users to logon with CWA but every time we get "Your session has expired. Sign on again".We successfully get to the portal and can logon, change password, accept conditions but then we just get the session ...
I'm having issues with a 1921 and a new 4G card.Below is the running config, show cellular and debug. The SP is EE in the UK, the APN is supposed to be everywhere, eesecure is the user and the password is also set (although not shown). The SP has c...
I've a got several 6500's with DMVPNs configured. I want to do the following:router eigrp 10 address-family ipv4 vrf FRED autonomous-system 10 address-family ipv4 vrf WILMA autonomous-system 20then add the network statements etc.This works on 2800 a...
Thanks Jan, do you know if this is by design, even across nodes in node groups? I'm guessing that Bug CSCul10677 is the same issue.Thing is, it rather makes the CWA static IP/Hostname option redundant/useless in a resilient configuration. It also m...
It's a bug CSCug43453basically you need to reset the modem after a reboot.so I entered test cellular 0 modem-power-cycleAfter this the unit will connect until the unit is rebooted/powercycled.
I did try but it makes no difference. The Cellular interface does not, at this point, have an IP address so NAT is not performed (there is no IP to NAT to).The failure is at Layer 2 in that the modem command does not get a response to activate the i...
