Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to setup NTP on a 2921 router to get time from various NIST time sources via URL instead IP address. However, I cannot seem to get DNS initialized on this router receiving the error message DNSIX: Dnsix is not enabled from the show dns c...
We are looking at relocating our data center which is presenting a few interesting situations. Not all of the systems can be moved at the same time which brings up the need to extend at least one and maybe more VLANS across the data centers until a...
Our PCI scan vendor has recently began flagging the outside interfaces of all of our firewalls that have AnyConnect enabled on them. Does anyone know if there is a way to enable HSTS on AnyConnect / WebVPN or the outside interface?
I am trying to configure a floating route but an aggregate route already exist in the routing table. As such the floating route is more specific and gets inserted into the routing table immediately. Does anyone know of a way around this?
Here is m...
I am in the process of setting up an FlexVPN connection between two ASR 1001-X routers running IOS XE Version 03.13.02.S. The routers are currently in a lab but will ultimately be used to connect the corporate office with a remote data center. I a...
The DNS lookup isn't working because the path to the name servers is via the management VRF and it won't split as configured. There isn't any need to pursue this any further because the router isn't capable of doing what I need it to. That being us...
It is a routed interface. The router is an ASR 1001-X.
That's pretty much what I thought. Don't know why I can't ping across though. When I'm looking at the switchport interfaces on the switches I'm not seeing a MAC address learned on that interfa...
I have configured the tunnel and xconnect is showing that it is up on both ends but I'm unable to ping across it. The layer 2 connection to the end devices are configured as access ports. Do they need to be configured as trunks? Should the router ...
Can this be used If I have an existing tunnel that's using the VPLS interface as a tunnel end point?
I've been exploring the use of VRF's to achieve some of what I'm thinking of doing but with a tunnel already in place it complicates things. If I cr...
That is besides the point. The scan engine is still detecting this alleged vulnerability that prevents us from being PCI compliant. I can contest it for now but they will still require the solution to be implemented at some point in the near future...
