Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allIn our branch site we got 3560 switch and Two switches 2960. Both the 2960 switches are connected to 3560 and all working.To have back redundancy we want the unuse port on both 2960 to connect to each other.3560 gi0/0--------------------------...
Hi GuyzI wanna upload ios image of 36mb on a 2801 but I get error not available space. The router already has ios image of 40mb and availabe space is around 15mb. Anyone can help how to delete existing image and upload the new imagecheersPaul
HiDesktop / Laptop / AP / Printers are connected to the switch 2960. which command on cisco switch tells me the distance or cable length from switchport to the host. cheeersPaul
HiOne Host on inside network needs to access customized application hosted on Internet. Its a customized application run on port 80, 443, 5000-to-50020 How do I allow this host access for this specific application. I got ASA 5510 and host is in the i...
HiAP cannot register on WLC 5508. WLC connects to 4507 as trunk port. Layer 2 vlan / Layer 3 vlan and DHCP Scope are configured on 4507. On WLC the interface got IP address and DHCP IP address. Access Points connects to POE Switch. There is a trunk...
Hi EdisonI understood your point on F3/0. Simple IPSEC didnt work so we started testing with Tunnel config and keeping IPSEC.Can you explain difference between IPSEC over GRE and GRE over IPSEC.can you suggest possible solution to make this workingch...
Hi allrizwanr74 -> my requirement is different then the linkJohn thanks mate for supporting the post, my default route is to send all traffic to firewall-box then how to send new vlan traffic to new DSL Router. i also dont want new vlan to use our ...
