Does anyone have a go-to guide for swapping out a failed supervisor card on a 6509 chassis? The guides on the Cisco site seem old with CatOS references.Thanks
Thanks all. Supervisor now installed.All good except a hand full of fibre ports went err-disabled due to UDLD when the module slotted home, anyone seen this?
Thanks Glen,My main question is around the existing compact flash in the failed hardware, should I put that into the replacement module, will the supervisor boot from that or the on board flash card on the motherboard by default?
Hi Reza,Yep we are configured in SSO mode and the backup failed. I have a 6504 chassis I can use to configure the replacement, just not sure of the steps needed. Can I stick the Flash from the faulty Sup into the replacement?Thanks
If you have a console you can try and boot into ROMmon and xmodem an image to the switch. Be sure to change up the baud rate or you will be there all night. Google the above for a step by step guide..Good Luck!
I have changed the field proxy-server address to my internal IP address of ourcall manager. Do i now put the external proxy address for the cucm in enterprise parameters or can i do it on a per phone basis...?
