Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am going to connect a Pix 501 to a cable modem. It is going to use DHCP. I am going to use the following configuration but have a question. I need to be able to get a Remote Desktop Connection on a server behind the PIX. I am going to have only 1 o...
I have a 2600 and I am trying to configure subinterfaces on a f0/0 port. I read that my code supports vlan encapsulation but when I try to add encapsulation 802.1d to the interface the command is non-existant. Here is the show ver and the error messa...
Having an issue getting a vlan to work. I have a Cisco 2801 router configured with sub interfaces and have some questions. I have a 10.1.1.0 network which is Vlan 1 and a 10.1.2.0 network (both /24)Vlan 2 The switch is configured as a trunk on the up...
Thanks but the encapsulation command doesn't exist. I verified that the router/code supports vlan encapsulation but it isn't allowing me to enter the encapsulation command.
My bad. typed in d insead of q. but stillRouter(config-subif)#enc?% Unrecognized commandRouter(config-subif)#?Interface configuration commands: arp Set arp type (arpa, probe, snap) or timeout backup Modify backup parameters ba...
