Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Attached is a visio of main DC WAN edge. Right now our WAE (7341) is placed directly off of ncmc-dc-rt01. Now we need to start to optimize traffice comming from all three top routers (ncmc-dc-rt01, ncmc-dc-rt05, and ncmc-dc-rt04). Were would be the b...
We have a three data centers connected via DS3s in a triangle formation. Each DC has two 7206 routers with one DS3 going into each. We have WAAS currently, but we aren't optimizing the traffic over these DS3s. Currently the WAEs are directly connecte...
We are beginning to install MPLS. We would like to install MPLS over a DS3 between a 7206 and a 2811. I am concerned that we will see performance issues with the 2811. Any ideas? Is there anyone doing this?
Our network is divided into two parts (each part is managed separately). Long ago we decided to merge our routing protocols using OSPF. Our side has seen some issues with OSPF because of its inability to load balance the way we want. For example: we ...
The WAN links from our remote sites are equal in cost, but depending on what traffic is being generated their destination probably has a shorter path on only one link. So the preferred path is the one that is having issues while the second path is no...
Two things: I am running QoS for the voice traffic over these WAN links. And... Part of the problem is that the shortest route to a destination will usually favor one of the links. The link that is favored is usually the link that is getting hammered...
No. I am trying to setup SLB between the two callmanagers and one of the methods of SLB requires a loopback address on the CCM. I think I am going to use the direct method of SLB which does not requre loopback addresses.Thanks
I have attached a high level view of a part of our network. The remote sites in the middle with the redundant links to MMC and ncmc-dc-rt01 are the ones that we are having issues with. As you can see from the picture LHC is overusing one link and har...
