Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have two HSRP routers doing dynamic NAT on two diffrent (outside) interfaces. Is it possible to map the two HSRP groups to SNAT? It seems 12.4 IOS, at least, supports only one SNAT definition.Thanks and regards,ioan
Hi, I've upgraded LMS from 2.5.1 to 2.6. I also applied an RME patch so that its version is now 4.0.6.Now I can't retrive the config files anymore. When I go to Device Centre and click on "View Config", I get the error message below in the browser. D...
Hi, When mgcp config is downloaded from CCM, is there a need for the (pots) dial-peers anymore? The MGCP gateway is 3845 router with 12.4 IOS and the CCM has version 5.1. The router has eight T1 PRI ports (to PSTN) but the CCM has not created any dia...
Hi, Does anybody have a sample config for enabling SIP on IP Communicator when talking to CME? I don't see "type CIPC" on the SIP side of CME (under voice register pool); also, is there anything special to be configured on the IP Communicator?Thanks,...
Hi, Thank you for your reply. My question is, is it possible to have SNAT configured on two different intertaces? Say one router has one inside interface and two "outside" interfaces. I'd do dynamic NAT on both "outside" interfaces. In addition, ther...
*** Device Details for tyogtcorml01 *** Protocol ==> Unknown / Not Applicable CM0057 PRIMARY RUNNING Config fetch SUCCESS, archival failed for tyogtcorml01 Cause: CM0002: Could not archive config Cause: Device may not be reachable, may be in suspen...
Yes, I did this but the job fails. There was no problem with LMS 2.5.1. Besides, with the prevoius version, when there was no config saved by RME, CiscoWorks gave clear message about it not the kind of message I'm getting now.Where can I look further...
Hi Rob, Thanks for your reply. If I understand correctly, if ccm config is used AND if "isdn bind-l3 ccm-manager" is present under serial port, there is no need for dial-peer (which would bind the respective voice-port to mgcp).However, from what I k...
