Hi All,
please check if below configuration is applicable on Cisco Nexus 7000. I need to capture all traffic destined to port 80 and copy it to a server for further analysis. I decided to use ACL capture but not sure if this will work.
monitor se...
Hi Experts,
Is it possible to get the values of allocated, free and used memory for below tables on ASR9K and ASR903 using CLI:??
BGP table
IP Routing Table
LFIB Table
CEF Table
MAC address Table
kindly share the CLI if exists.
thanks,
Haitham Jn...
Hi Experts,
I am planning to to deploy Arbor on ASR9000 using VSM card. I need some documents/references which explaining the solution and deployment requirements/procedures.
thanks,
Haitham Jneid
Hello Marvin,
I have FWSM module on 6500 switch. I need to upgrade FWSM to firepower 4140. please I need your recommendation on this .
much appreciated.
thanks,
Haitham Jneid
Hi Nitin,
I really appreciate your informative feedback. could you please explain for me the BGP flowspec config.
router bgp 65000 bgp router-id <rtr_id> address-family ipv4 unicast ! address-family ipv4 flowspec !neighbor-group ibgp-routers // for ...
Hi Aleksandar,
yes I went through it and it was very useful, but I need to know the exact bgp configuration from ASR side and from VSM TMS side. real example if possible.
thanks,
Haitham Jneid
Hi smailmilak,
Actually I am preparing for a project and still not have a BoQ. that's why I need to understand the solution more.
I already implemented such a project but it was totally on arbor appliances. this project will be using ASR9K VSM to ac...
Hi Nitin,
May you please support me on my previous request?
Also where I can find how to configure the TMS on VSM via GUI ? any documents?
thanks,
Haitham Jneid