Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hello everyone,
I have a 3550 Layer3 switch with 2 svi connected to an asa 5506 i don't know what i'm doing wrong but the ASA is allowing only the native vlan of 3505 switch to the internet. i can not get to internet from the hosts on the two vlans ...
Hello everyone
Im trying to create a lab using GLBP for two different Vlans. I understand how it will work if i have a layer two switch in the middle between R1 and R2 but since i have a layer 3 switch between R1 and R2 and there is svi setup for ea...
Anyone has a solution for this. I can create point 2 point gre tunnel between two location and i can ping the tunnel interface but if create dmvpn i can not ping the tunnel internface on either sides. i would appreciate any suggestions thanks HUB ro...
Sorry i meant to say it does have a default route point to ASA inside interface. The problem i'm facing if you look at my ASA config I the ASA only allows the native vlan on layer3 switch to the internet. I'm new to ASA don't know what i'm doing wron...
hi Marvin,
I have Two Svi created on a layer3 switch the svi is the gateway for different computers in the subnet and the link between layer3 switch and the ASA is set to Layer3 port " it has a /30 ip add assigned to it" and i have configured a defa...
