About hashimwajid1

hashimwajid1 · 08-16-2026

Hellois it possible to do manual profiling with Essential licesne only. i want to do it for MAB devices and i am manually importing the MAC addresses in bulk. i just want that Vendor or Device type should be visible under endpoint Radius logs (Axis/C...

hashimwajid1 · 07-22-2026

Hi,I am planning to connect AXIS CCTV cameras to Cisco Catalyst 9300 switches that are integrated with Cisco ISE. The cameras will authenticate using MAB (MAC Authentication Bypass) via RADIUS.My primary concern is maintaining stable, uninterrupted v...

hashimwajid1 · 07-20-2026

HelloI want to connect CCTV cameras to a Cisco Catalyst 9300 switch. The switch is integrated with Cisco ISE for both TACACS+ (device administration) and RADIUS (network access control). I plan to use MAB for the cameraWhat is the recommended interfa...

hashimwajid1 · 07-12-2026

hello i have installed SSM On-Prem in Air-Gapped enviornment and trying to upload Activation file on SSM On-Prem after validating on Cisco Smart Portal.1- created new Account Request on SSM On-Prem and download the registeration request file on PC.2-...

hashimwajid1 · 05-21-2026

Hi,i configured Stackwise Virtual between 2 x C9500 24Y4C, however i dont have enough SFP to use dedicated DAD link, i am planning to use ePAgP DAD to prevent Split Brain Scenario. 2 x C9500 Core Switches will be connected to Downstream C9300 48P Swi...

hashimwajid1 · 07-23-2026

Thanks Arne, i was not aware that Axis Cameras supports dot1x, i will check this from CCTV deployment team, But i will add same Access VLAN as backup VLAN in case main site goes down or ISE not reachable from remote sites cameras

hashimwajid1 · 07-22-2026

Thanks @aleabrahao dont you think by using **authentication periodic and authentication timer reauthenticate server** commands, it could cause issue for CCTV Camera stream for few Milli Seconds? i mean what advantage or disadvantage i would get for...

hashimwajid1 · 05-21-2026

@Mark Elsen @Kasun Bandara Thanks for your reply, i tried the following commands and its wroking, my question is what are the disadvantages/Cons/challanges i can enctounter in future as SFP is detected by switch now. i undertstood cisco does not off...

hashimwajid1 · 03-25-2026

i configured speed manually on Peer Firewall Interface and it worked, Thanks, Hundred Gig Interface on Catalyst does not support autonegotiation i believe.

hashimwajid1 · 02-21-2026

i'll try this

Member Since	‎05-24-2017 11:54 AM
Date Last Visited	‎08-16-2026 08:06 AM
Posts	227
Total Helpful Votes Received	34

User Statistics

User Activity

Can we do ISE Profiling Manullay with Essential license only

Should Periodic Reauthentication Be Disabled for MAB Camera Ports

Cisco Catalyst 9300 RADIUS Commands for MAB only Interface

SSM On-Prem Error when uploading Activation File

is C9500 Stackwise Virtual EPagP DAD as Reliable as Dedictaed DAD ?

Re: Should Periodic Reauthentication Be Disabled for MAB Camera Ports

Re: Cisco Catalyst 9300 RADIUS Commands for MAB only Interface

Re: Cisco Catalyst C9500 not supporting 1G SFP

Re: Cisco QSFP-40G Link Not UP on Catalyst 9500 Switches

Re: Cisco QSFP-40G Link Not UP on Catalyst 9500 Switches