Hello guys, I'm looking for a command line which disable the simultaneous access to privileged EXEC mode on Cisco switches, so no other administrator can access the EXEC mode until the accessed administrator get out of the EXEC mode. Many Thanks 

Hello Everyone,I'm not so familiar with OID things,but i did a new Radius configuration to achieve a Radius failover  on our switch using command:  radius-server deadtime 1I tried to find the OID that represent the deadtimer  to monitor the failover ...

Hi All, recently i updarded my siwtch Catalyst 2960-24TC-L from 152-1.E1 to Release 15.2(2)E6 , after the update the IP device tracking is enabled in ports have configured as do1x authentication only, and any other normal ports ( without dot1x) the i...

Hi All, is it possible to copy the IOS file in Cisco Stackable switch from FLash1 to Flash within the same Switch ? SW01#copy flash1 flash2 if  yes , is it safe not make any harm to flash or switch Many Thanks

Hello Everyone ,I have an issue with  switch 2960S stackable with IOS 15.2(1)E1 as the whole network is down and i couldn't ssh the switch. After reboot i got the SSH and I checked the log and i found the following msg:  %AAA-3-ACCT_LOW_MEM_UID_FAIL...