Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a bunch of switches that are running fine but the running-config file is missing and we can't save the config to the tftp server. Anyone else seen this? IOS is c3550-ipbasek9-mz.122-37.SE1. I've got lots of these switches running the same ...
We're seeing a higher than expected power supply failure rate in our catalyst 3550-24 poe switches since we put a number of them behind RPS 2300 units last summer. We've had a couple of dozen failures as compared to a single failure of a 3550 not be...
Anyone out there doing this? I can get the channel to come up, but the 3508 can only seem to pass traffic on whichever link of the two in the channel comes up first. The 2nd link shows no STP running as I expect it should (based on doing this betwe...
I have a couple of Cisco WS-G5483 1000Base-T GBICs that do the following when inserted into a switch:- don't generate the console message indicating that a GBIC has been inserted- in the output of a SHOW INTERFACE STATUS, the GBIC is listed as a 1000...
We have an old copy of CW2000 Campus (RME+CSWI) for HP-UX 10.20.We finally have a machine with enough disk and ram to actually run it to see if we want to keep it (it's been sitting on a shelf for a couple of years...)The essentials OSG won't stay ru...
That's been our experience as well. As to the E-series, yes, they're built for the RPS. We added the RPS units to an existing network of non-E units so we get to live with things like once the non-E units go over to RPS, you have to reboot them to ...
Sure thing. I don't think we've lost any 3560's yet, but they're a small number compared to the 3550s. My problem is the 3550s are just past the 5-year limited warranty on the power supplies, so it's going to start costing me money if/when Cisco st...
Haven't turned up anything. Cisco is pretty silent on the issue and given the status of the 3550's, they're probably not in a hurry to do anything. We're still seeing failures. Have even had a few new (as of last year) 3750's die as well. Good lu...
Glen,Yes, the destination file name exists and read/write mode as required. It is the SOURCE file name it says is missing (system:running-config). When the destination doesn't exist or the permissions are incorrect, you get an error from the tftp se...
froggy3132000,Here's some output. That last error about the file system caught my eye but I get that same error from other switches that are working fine.TURNERST1-SW1#wri memBuilding configuration...[OK]TURNERST1-SW1#wri netThis command has been re...
