Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there ... I've a couple of ASA that when scanning, were reporting to have TCP port 110 openConfiguration doesn't allowed that, so even with an explicit ACL entry denying that traffic, port 110 was still respondingI telnet to port 110 to any natted...
Hi there ... I have a SG300 with MAC ACL. Is there a way to add more entries by CLI setting the priority? I know I can do that by GUI, but when I need to enter like 10 new entries, it'd be much faster to do it by CLI, but I couldn't find a way tell w...
Hi there .... I need to upgrade a pair (active/standby) of ASA from 8.2.5 to 8.4.3 ... I have a script created to modify all NAT rules I need, and I have tested it in lab, and I think I'm good with it.Now, I want to figure out if there's a way to do ...
Hi there ... I've ASA 5520 with 8.4(3) runningI want to set up VPN remote access using following document (https://supportforums.cisco.com/docs/DOC-18960)I managed to get a connection running, but when I check the connection on the ASA, it shows as a...
Could someone be kind enough to tell me how to disable intercom once it has been set up please? Any help would be greatly appreciated as a client requires it disabled. Am using CUE V7 if that is any help?Thanks
Thanks Jay ... I managed to get it working doing everything from CLI, instead of using ASDM, without uploading the distribution package for Anyconnect 3.0.5I see tunnel now to be built using IKEv2 instead of SSLI have a new question now, thoughIn the...
thanks for the answer ... to be clear ... just loading annyconnect on ASA is enough, or should I publish it through configuration?I am not ready for my users to get annyconnect 3.0 downloaded. We are still using 2.5 as standard solution. I just want...
Hi there .... I have followed these instructions, but I can't connect using IKEv2 ... my client connects to ASA and VPN is established, but all over SSL, not IKEv2What can be wrong about it?Also, I've found that the asdm client profile editor is dif...
Sure, here are some more notes- I have Annyconnect 3.0.5 installed on my PC, which I installed as standalone (not distributed from ASA)- I open it up and connect to the ASA using a URL- Different profiles show up. I chose the one I'm using for testi...
