Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am experience unusual problem with my new S190 two boxes, which can’t connect via serial interface or management interface. I have tried with management interface with default ip address+ port (http://192.168.42.42:8080, https://192.168.42.42:8443)...
I have configure 887 ADSL router with attached configuration. But users cant access internet properly. (Ex: yahoo and gmail mail cant access)Therefore please check the configuration with my network design which I have attached.Thank you,Chandimal.K
I am doing a installation on CiscoWorks 3.2. after two three weeks I found my syslog services is not working properly. Once I checked on the syslog.log its updated with the device logs as normal. But when I am going to generate report it’s not collec...
Hi Alain,Thank you very much sir, your solution works. So its due to the mtu size problem. So agine thank you very much for your knowledge sharing. Chandimal.K
Hi,Thank you Alain, Is there any other problem with my configuration? I have change the configuration as you told but problem still same. Still some web sites cant access via this ADSL router. Therefore can yu please check my configuration one by on...
Hi Aliain, Thank you very much, i'll check it and let you know. Anyway is there any problem with my NAT rule? i have only one public ip that i have to use for email server access like i mention on the config. if i use nat command with "extendable" ke...
can you please help me this is the configuration.! Last configuration change at 09:08:08 UTC Tue Dec 13 2011!version 15.1no service padservice timestamps debug datetime msecservice timestamps log datetime msecno service password-encryption!hostname S...
hi, Thank you for your reply. but i didnt work. Then i restore the LMS server again. but anyway thank you for your support. after i reinstalled the new server, now in that server SMTP setting cat set. its gives "Invalid IP address or server name fo...
