Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have implemented VRF Lite on Cisco 9410 switch. There are two VRF's "XYZ" & "ABC" configured on the switch. I have a situation in which I have to leak overlapping IPv4 routes between the 2 VRFs. How do I do it and what will be the best solution to...
For Site A I have configured IP SLA on ASA with primary default route pointing to internet circuit (on outside interface). When this circuit goes down the IP SLA kicks in and the default route points to the MPLS router (on the inside interface) where...
Hi All,I have wierd issue going on within network. There is a file server which is behind firewall connected to gig4/0/19 (output shown below). If the users in production network try to access this file server the speed is very slow (approx 50kbps) w...
Yes, the duplicate IPs are in use as well. This is just one sample subnet that I have mentioned and there are few other overlapping subnets that require a solution.
On the L3 switch I have a 10.10.10.0/24 subnet configured on a SVI which is already being used for servers and it belongs to VRF "XYZ". On the other hand I have a subnet 10.10.10.0/23 that is being learnt via OSPF which is in vrf "ABC". These VRFs we...
