Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a pair of Cisco Nexus 9508s running as a VPC pair, I am planning on placing Cisco ISR or ASR routers at my WAN edge to terminate my MPLS connectivity, I am trying to maximize my transit connectivity between the 9Ks and the routers.
Can I conn...
I have been banging my head on this problem for a couple days now and coming up with nothing. I have followed a couple/few configuration examples (http://www.cisco.com/c/en/us/support/docs/security/anyconnect-secure-mobility-client/118084-configure-a...
I have a pair of Nexus 5596s set up as a HA core running vpcs to several fabric extenders in my datacenter. I have a simple L2 VLAN I allocated for my Linux team to use as a "heartbeat/cluster" segment, their servers have a single interface to use to...
I have a pair of Nexus 5596s being used at the core of my datacenter network, I have several 2000 series fabric extenders connected to them using VPCs. What I am trying to do is install a pair of fabric extenders for my segregated PCI environment sh ...
I have an issue that I've been pulling my hair out on.....my telecommuters connect to our corp. network via an AnyConnect VPN connection (version 3.1) to a Cisco ASA5520. I do not have split tunneling enabled for this profile so all traffic should tr...
I was able to apply the command by using the "vlan configuration" command below on both 5596s.vlan configuration <Vlan ID>ip igmp snooping querier <IP Address> That still didn't do it though. I ended up building a VLAN interface for this VLAN and lef...
Thanks Jon....I had found that since I posted this, but the command "ip igmp snooping querier <ip address>" is not a valid command.....I'm not sure why though, the 5500 doc says it is valid. I may build a L3 interface for this VLAN and put PIM on it ...
Yea....probably not the best of explanations.....is there a way to create a "virtual data center" to segregate the FEXs.....as you mentioned the traffic I can segregate using just L2 vlans, limiting that traffic to just the "PCI" FEX ports, etc.........
Thanks for the reply Marius! I fixed this by just running "same-security-traffic permit intra-interface" on the ASA, I did not need to add the hairpin natting.Thanks for the help....Jeff
