Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Community, In the old Catalyst 3750, there was the remote command switch-number command to execute a command from the master switch to a member switch.Now, I have a Catalyst 3850 stack with version 16.12.5b and I cannot find this command. Howev...
Hello,
I have a switch 3850 with IOS-XE 03.02.03.SE.
I am trying to filter by MAC address using Vlan access-map, but it is not working.
So, I am trying to troubleshoot but there is no 'log' commnads as point in the config guide: http://www.cisco.com...
Hello Leo, Thanks for your comments and suggestions, I will review our switches behaviour and reevaluate the 16.12.X version. @Leo Laohoo wrote:The command "remote command" is not supported in IOS-XE. The "session" command is only supported in IOS-X...
Hello Leo, Thanks for your comment.Although it is an off-topic comment, I would appreciate it if you could extend your comment. Returning to the topic, the command does not exist in version 16.9.5 either.
It's been more than three years and there is still no stencil for this model.For people who still search for a visio of this model. A user made one and posted in the following link:https://community.cisco.com/t5/technical-documentation-ideas/visio-st...
