Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.Is there still a limit to the amount of IPs that can be configured in a DHCP pool? If there is a limit and we need more than 256 IPs to support our Remote Access VPN clients, can multiple pools be created to accommodate them? Thanks in advance...
We currently have one BGP process running on our router connecting to our Service Provider. Is it possible to create a subinterface, assign it to a VRF and then create a second BGP process within the VRF? We are in the middle of separating some sites...
Good morning. I am trying to create an IPsec tunnel (two actually) for use with Zscaler to send http and https traffic to. Right now, the setup is a ASA 5506 connected to the internet for internet based traffic and an existing IPsec tunnel to interna...
Hello all -I stood up an APIC-EM last week and have not been able to access the UI of the site. The grapevine services are running...but am still unable to access. I tried by recommended URL: https://10.0.11.225 as well as the grapevine developer con...
Hi Giuseppe.My apologies for the delayed response. But thank you. So the second BGP AS can only be configured on the PE side of the link? Ideally, we'd do it on both the CE and PE routers to start the divestiture. And when it's complete, remove the f...
Thank you Cristian (I love your videos on INE by the way). In the past, there was a limit. Is that no longer the case? For all ASA models, the maximum number of DHCP client addresses varies depending on the license:If the limit is 10 hosts, the maxi...
Hi. We are attempting to do the same thing. We would like to have a splash page that shows an Acceptable Use Policy and then allow them to connect to the Guest network. Connecting would happen via PSK (which we would provide). We don't want any authe...
Hi. Thank you for your replies. Please see the output requested from Packet Tracer below.
And no, I don't see the phase 1 or 2 tunnels up.
HTMK1ASA01# packet-tracer input inside tcp 10.12.0.51 50000 4.4.4.4 80
Phase: 1Type: ACCESS-LISTSubtype:Res...
