hi,i am new to cisco and would like to get some advice.we are planning to purchase some new 2960x switches over internet from vendor A.however we find vendor A, smartnet pricing is too high.could we purchase from vendor B if the pricing is lower?Do I...
Hi,
We have a C3850 switch and I could see 2 vty sessions hanging for sometime now.
sh users
Line User Host(s) Idle Location 1 vty 0 idle 1w5d hp22-840 2 vty 1 ...
Hi,
We have configure the etherchannel in our cisco 2960-X to SG350X successfully with 2 x 10G SFP+.
In 2960X we are able to see the BW (bandwidth of 20000000 kbit/sec using the command show int po1
However when issue show int po1 in SG350X it only d...
We would like to replace our old 2960g-8tc-l (with SFP uplink) with 2960X-24TD-L with 2 SFP+ port.
1) Could 2960X-24TD-L (2 SFP+ port) run with the configuration of :
- 1 - SFP+, 10GBASE-LR transceiver module,
- 1 - SFP, GLC-LH-SM transceiver mod...
Hi Leo,
Thank you.
What we wanted to achieve is the below
existing 3750G - 1G uplink connect to the new 2960X-24TD-L - 1G uplink (1st port), 2960X-24TD-L - 10G uplink (2nd port) connect to Cisco SG350X (1st port).
This will work right? Thanks.