Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi. I have in front of me an SG300-52P.It is hardware version V3, as shown both on the sticker on the back, and from "Status and Statistics", "System Summery". It is currently running firmware version 1.3.5.58, which is quite old. I wish to upgrade t...
Hi. Not sure where I should be posting questions about this forum itself, so posting here. Yesterday, started a new thread. Today it seems to have vanished. When I browse through VPN and AnyConnect, where I posted it, the posting does not apear. One ...
Hi.I administer a network with an ASA-5508X, which is configured to support anyconnect clients. It currently runs FTD 6.2.2.1, and is managed by a vFMC running Cisco Firepower Management Center, version 6.2.2.1. (I will at some point upgrade these to...
I administer a site with several FTDs, controlled by a vFMC. At the time of installation, around a year ago, I heard rumours from various sources that support for HyperV was "Roadmapped". Since we use HyperV exclusivly as a virtualisation host, I pur...
I have an ASA-5508x, adminstered by a vFMC. Both are running 6.2.2.1. Note that this is FTD, not the older ASA software. I have a server behind the 5508, in a DMZ, that I want to have send email via an SMTP connection to Office 365. The problem I am ...
I assume that here is a switch between the ASA and DHCP clients? If so, and it is managed device, check that DHCP snooping is correctly configured. More here, for some Cisco switches. https://www.cisco.com/c/en/us/td/docs/switches/lan/catalyst3750x...
Thanks. Being a sceptical sort of person, I tried this anyway. Seemed to me that it was more about the client end than the head end. I put together an appropriate profile, loaded it onto the FTD, and gave it a try. Did not work. The VPN failed to con...
After a bit of looking, I also filled out a form accessed from the "Community feedback" link at the bottom. Unsure if that is the correct way to proceed with a request for spam review.
OK for anyone else following, I eventually figured this out:1. Create a Flexconfig policy, apply the Default_Inspection_Protocol_Disable, System defined object.
2. Go to Objects, Flexconfig, Text Object. Edit the disableInspecProtocolList to include ...
