Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I am looking to cluster the aformentioned switches using the CLI. All the documentation that I have found all speak to performing the cluster configuration using CMS. I can only get to these switches via remote console so a GUI is out of the ...
Once you have tuned a false positive in MARS. Where can you go to view the signatures that you have tuned? I know the "False Positive" tab only shows some of the tuned signatures, but where can I go to view all user created false positves after the...
Hello,I am able successfully view Cisco MARS netflow messages in the GUI. However, how can I tell if any of the netflow details that I am seeing real-time have generated an incident? I have run the report "Activity: All Events and Netflow- Top Dest...
All,I have been tasked with the configuring centralized authentication via IAS for all the IPS/IDS devices in the enterprise. After much invest I'm almost sure that due to limitations inherent to the device my goal is not obtainable. However, I am ...
I configured SSO on a 3925 IOS 15.1 using a doc that wat titled Stateful Failover for IPsec. I am not using IPsec so I did not configure the IPsec part. However, my goal is maintain state information between my two routers in an active/standby pai...
What about using stateful NAT with overloading the outside interface? I am not able to code the keyword "mapping-id" which would cause the active router to exchange state information with the standby. I have 3925 router. I can only code the mappin...
