Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I'm missing on the C3650-24 TS the command "errdisable recovery cause small-frame".I'm using the Cisco IOS Software: IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.03.04SE RELEASE SOFTWARE (fc3)(config)#errdi...
Hello,is it possible to configure "duplex auto" and speed auto" on an interface where a SFP module is inserted?E.g. on an IE-3000-8TC with GLC-FE-100FX-RGD or Cisco WS-C3750G-12S with GLC-GE-100FX?Thank you very much for your answer.Kind regardsKyle
I want to test NAT-PT (I know it's deprecated) between an IPv4 host (Host_B) and an IPv6 host (Host_A). Host_A<---->881<---->Host_BHost_A and Host_B are directly connected to the Router. Host_A: 2001:345::2/64Host_B: 192.168.123.2 ipv6 uni!int vlan2i...
Hello Community,I found a lot of information to handle an IPv6 over IPv4 communication, but almost nothing about IPv4 over IPv6.Which possibilities exists integrating IPv4 over IPv6 on a Cisco Router (e.g. 881, or perhaps a Layer 3 Switch)?Are there ...
Hi Madhukrishnan, the show version output is:Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.03.04SE RELEASE SOFTWARE (fc3)Technical Support: http://www.cisco.com/techsupportCopyright (c) 1986-20...
