12-17-2014 04:58 AM - edited 03-07-2019 09:56 PM
Hello,
I'm missing on the C3650-24 TS the command "errdisable recovery cause small-frame".
I'm using the Cisco IOS Software: IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.03.04SE RELEASE SOFTWARE (fc3)
(config)#errdisable recovery cause ?
all Enable timer to recover from all error causes
arp-inspection Enable timer to recover from arp inspection error disable state
bpduguard Enable timer to recover from BPDU Guard error
channel-misconfig (STP) Enable timer to recover from channel misconfig error
dhcp-rate-limit Enable timer to recover from dhcp-rate-limit error
dtp-flap Enable timer to recover from dtp-flap error
gbic-invalid Enable timer to recover from invalid GBIC error
inline-power Enable timer to recover from inline-power error
l2ptguard Enable timer to recover from l2protocol-tunnel error
link-flap Enable timer to recover from link-flap error
loopback Enable timer to recover from loopback error
mac-limit Enable timer to recover from mac limit disable state
pagp-flap Enable timer to recover from pagp-flap error
port-mode-failure Enable timer to recover from port mode change failure
pppoe-ia-rate-limit Enable timer to recover from PPPoE IA rate-limit error
psecure-violation Enable timer to recover from psecure violation error
psp Enable timer to recover from psp
security-violation Enable timer to recover from 802.1x violation error
sfp-config-mismatch Enable timer to recover from SFP config mismatch error
storm-control Enable timer to recover from storm-control error
udld Enable timer to recover from udld error
vmps Enable timer to recover from vmps shutdown error
The Security Configuration Guide, Cisco IOS XE Release 3E (Catalyst 3650 Switches) shows this command, but I'm not able to use it.
Can you help me?
Kind Regards,
Kyle
01-12-2015 11:44 AM
Hi Kyle,
Please send me a show version output
Thanks,
M
01-13-2015 06:04 AM
Hi Madhukrishnan,
the show version output is:
Cisco IOS Software, IOS-XE Software, Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M), Version 03.03.04SE RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2014 by Cisco Systems, Inc.
Compiled Fri 29-Aug-14 22:22 by prod_rel_team
Cisco IOS-XE software, Copyright (c) 2005-2014 by cisco Systems, Inc.
All rights reserved. Certain components of Cisco IOS-XE software are
licensed under the GNU General Public License ("GPL") Version 2.0. The
software code licensed under GPL Version 2.0 is free software that comes
with ABSOLUTELY NO WARRANTY. You can redistribute and/or modify such
GPL code under the terms of GPL Version 2.0.
(http://www.gnu.org/licenses/gpl-2.0.html) For more details, see the
documentation or "License Notice" file accompanying the IOS-XE software,
or the applicable URL provided on the flyer accompanying the IOS-XE
software.
ROM: IOS-XE ROMMON
BOOTLDR: CAT3K_CAA Boot Loader (CAT3K_CAA-HBOOT-M) Version 1.2, RELEASE SOFTWARE (P)
XXX uptime is 1 minute
Uptime for this control processor is 3 minutes
System returned to ROM by reload
System image file is "flash:packages.conf"
Last reload reason: reload
This product contains cryptographic features and is subject to United
States and local country laws governing import, export, transfer and
use. Delivery of Cisco cryptographic products does not imply
third-party authority to import, export, distribute or use encryption.
Importers, exporters, distributors and users are responsible for
compliance with U.S. and local country laws. By using this product you
agree to comply with applicable laws and regulations. If you are unable
to comply with U.S. and local laws, return this product immediately.
A summary of U.S. laws governing Cisco cryptographic products may be found at:
http://www.cisco.com/wwl/export/crypto/tool/stqrg.html
If you require further assistance please contact us by sending email to
export@cisco.com.
License Level: Ipbase
License Type: Permanent
Next reload license Level: Ipbase
cisco WS-C3650-24TS (MIPS) processor with 4194304K bytes of physical memory.
Processor board ID FDO------
3 Virtual Ethernet interfaces
28 Gigabit Ethernet interfaces
2048K bytes of non-volatile configuration memory.
4194304K bytes of physical memory.
250456K bytes of Crash Files at crashinfo:.
1609272K bytes of Flash at flash:.
0K bytes of Dummy USB Flash at usbflash0:.
0K bytes of at webui:.
Base Ethernet MAC Address : a0:ec:f9:db:98:00
Motherboard Assembly Number : 73-15127-05
Motherboard Serial Number : FDO----------
Model Revision Number : D0
Motherboard Revision Number : A0
Model Number : WS-C3650-24TS
System Serial Number : FDO--------
Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 28 WS-C3650-24TS 03.03.04SE cat3k_caa-universalk9 INSTALL
Configuration register is 0x102
01-13-2015 11:16 PM
Can you try other IOS-XE versions, like 3.6.X or 3.7.X?
02-06-2015 05:42 AM
Hi Leo Laohoo,
even with 03.07.00E there is no "errdisable recovery cause small-frame" possible.
Please help.
01-20-2015 01:43 AM
I think you are looking at config guide for 3.6 and on switch you are not running it on switch.
01-23-2015 02:19 AM
Deat Kyle,
Would like to know whether the above helped you.
if it helped, request you to accept as solution.
Thanks,
Madhu
06-08-2015 01:55 PM
Kyle,
Errdisable detection is turned on by default for all causes with the exception of small-frames. You'll first need to enable the feature with the global errdisable detect cause small-frame command. Have you done that?
Please rate helpful posts.
Thank You,
Andy
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide