Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have three Cisco ASR1002 that my boss just dropped in my lap and told me to factory reset and configure for our datacenter. I tried the CTL-Break trick but it keeps booting to the logon screen where I don't have the login credentials (neither does ...
I have been asked by my CTO if the C3750X switches we are currently using as a core are recommended for WAN switching. I have done some homework and from what I have gathered the answer is no, but what would be a hardware recommendation. I don't have...
My company is in the process of being audited (annual event) and my manager wanted me to lock down access to our switches from our workstation network for ports 80, 443, 22, 23. I created access-lists and applied the access-lists to our "traversing" ...
I am trying to clean up some routing issues I have between sites. I have three sites (A, B, C). Site A is the main location. Site B is a branch location connected by a 50 Mbp pipe. Site C is our COLO connected by VPN. Routing between Site A and B is ...
A couple of quick questions here (5508 WLC, 1142N APs).I understand if I enable the AP mode to Rogue Detector from the details page of the AP, the AP stops accepting requests and is now looking for rogue items on the wired network. Is this the same w...
With all due respect Leo, I went down this path already and when I clicked your link all of the links that were on the first three pages I have already reviewed. If I can get into the router I can factory reset it, I just cannot log on and trying the...
Thank you guys, both are good answers.On another note, I have a company in a building next to ours and their WIFI range is bleeding over and my WLC is picking them up. Right now I have just set it up as contained. My new question is, they are not fri...
I have a standalone 5508 WLC. On the Monitor/Summary page, to the right there is the Rogue Summary section. My third line item is Adhoc Rogues and I have three listed. When I select the Details link only one shows up. I remember checking this a week ...
I am trying to use MS AD for my LDAP server. I am reading that it may not work (which is frustrating). I am also getting the following error... Unable to find a certificate to log you on to the network. I am just trying to get this up and running. Cr...
Thank you for the quick reply David,We are using authenticated bind. I do not have the rights to make changes in ASDI and unless I can get a super good reason to use anonymous bind, that is out of the question. I did check the show ldap statistics on...
