Hi all, we noticed that our operational backup is now up to 25GB large, which is too large from our perspectiv. After some research we found out, that with deploying DNA Center, the amount of authorization log data incrises rapidly. This is because D...
Hi, I want to send only specific syslog messages to a certain syslog server.On IOS I can use a TCL script to tag this messages with an ID and then use the command 'logging host x.x.x.x filtered stream YX' to send only the messages with the ID XY to t...
I want to configure sampled netflow on a L2 3560G Switch and need your help.
My config looks like this:
flow exporter EXPORTER-1
flow record FLOW-IPv4-L2-RECORD
match ipv4 tos
match ipv4 protocol...
Hi all,I'm trying to implement SNMP monitoring to ACI. I found this guide:https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/mib/guide/b_Cisco_ACI_MIB_Quick_Reference/b_Cisco_ACI_MIB_Quick_Reference_chapter_01.htmlAfter finishi...
I have the requirement to disable the syslog rate-limiting for a special syslog message on Nexus switches. We have a management system, which tracks the syslog-events which occur, when you leave the config mode e.g.
08:46:27.126 SWITCH %VSHD-...
I just want to export netflow data that is going through one L2 interface and not through the whole switch. How can I specify this, if I apply the flows to the SVI?
In your link from above the flow Monitor is also applied to the relevant...
thank you for your reply. I want to export data that passes the switch and not data, that is send to or from the switch. So I think the link discribes that what I want.
I updated the flow record but without any improvement.
flow record F...
I tried all steps mentioned above to get TACACS working with PI 3.0 and ACS 5.5, but get still the message:
"No authorization information found for Remote Authenticated User. Please check the correctness of the associated task(s) and Virtual ...